How To Clean Using Seal Gun Cleaner

Print this Page

Not bad Stuff Pro Gun Cleaner – Aerosol cleaner

Great Stuff^® Pro Gun Cleaner is a aerosol cleaner for guns laying polyurethane cream. Suitable for cleaning of not hardened cream from various surfaces. The production is equipped with an adapter for manual work, stable attached to the can.

Cleaning unhardened polyurethane cream from the application guns
Manual cleaning of contaminated with unhardened polyurethane foam surfaces or equipment

Easy to use
Can with stable attached adapter for manual piece of work
Quick cleaning
Economical

Working with a gun
Before unscrew the can with foam from the gun, mountain the adapter for manual performance on valve of cleaner. If the nozzle of the gun has accumulated unhardened polyurethane foam, clean it by pressing down the adapter and straight spray to clean the place. And then remove the adapter for handwork from the cleaner valve. Spiral the flow adjusting spiral of the gun and so that it blocks the trigger. Unscrew the tin can with foam from the gun and clean the valve of the gun and the can with foam if it provides its reuse. Areas for cleaning must to exist in a position that permits the leakage of dissolved foam.
Immediately after this screw cleaner tin to the valve of the gun. Unscrew catamenia adjusting screw of the gun at to the lowest degree 3-iv turns.Direct the nozzle of the gun to the waste material vessel and repeatedly pressing the trigger until the gun nozzle starts spraying transparent spray.

Note that at the first pressing of the trigger, the gun will extrude small corporeality of foam. Do non try to use this foam to seal.

Handwork
Place handwork adapter on the valve of the cleaner can. Direct the spray nozzle to the cleaning expanse and press down the adapter. It is recommended for cleaning vertical or other surfaces to utilise soft cloth for wiping the dissolved foam, to prevent it from falling on adjacent surfaces and to avert the appearance of spots after cleaning. Wipe should exist done immediately later the dissolution of the foam.

This production is intended for cleaning of not hardened polyurethane foam. Already hardened polyurethane foam tin can be removed mechanically.
Before starting work, remove all sources of fire, sparks and estrus. The can contains a highly flammable gas аnd solvent.
Use personal protective equipment for the torso, eyes and easily.
Protect cans from heat and directly sunlight during storage and transportation.
Cans containing product at high pressure. Exercise not perforate or burn cans, even afterwards their discharge.
Practice not direct the spray foam to humans, animals, plants and other living organisms.
Environmental protection is essential. Dispose of workflow waste separately in designated places.